To remove a car radio installed

Car radios are installed in the car for a more comfortable and enjoyable. For most people today, a car radio is an essential element of their cars. They are the heart of the car audio system and are placed well designed and equipped to meet the interior of the car.

Now it may happen that sometimes instead of the pre-installed car radios every year, you may want to try a better system. But the lack of knowledge concerning specificRemoving an installed car stereo can be a hindrance. But in this case is to be noted that although the removal of a car radio installed is not a tough job, but caution is advised, because the procedure is technically are.

Pioneer Wiring Harness

The process of removing an installed car stereo depends on the type of stereo and car type. There are generally two ways to remove a car stereo, mounted the spring clamp and bolt-on. In the first, the stereo instead of 4 small placeClips so that the stereo does not slide out from the dashboard. The tools are there to remove a pair of DIN tools, which are generally U-shaped And at the top of the U's just that the stakes in the stereo clip-fix. It's just after loading, there is a tick and just pull the stereo out of the dashboard.

There are radios that are connected to the dash and then it becomes a little 'hard to get it out. However, there are special tools for removalProcess. There are brackets bolted to the machine. Sometimes they are mounted on the stereo, to bring some variation in the method. However, the screws or bolts holding the stereo in place of access, some barriers must be removed. And you have when you remove it carefully. This is the essence of the method and bolt-on.

Basically, there are one or two pieces, cut the face of the stereo surround. And hid him in order to remove the screws that are usually in plain sight to bereplaced. In fact, there are some hidden clips that are clean, and the need to remove the fairing. In this case, removal tools are used.

Well, if the strips are removed should remove the screws or bolts that holds it. If they are removed, the stereo image from the dashboard.

Then you should disconnect the electrical connectors on the back of the stereo through the antenna cable at first. In fact, the cable connecting the antenna close to the widerPassenger side. The next step is to remove power. Finally, you must remove the wiring connector on the back of the stereo. Now that all electrical connections are on the back of the stereo, the radio is completely removed. These are basic instructions for removing an installed car stereo system. In the event of a complication, you should give a call to the service center and get an expert.