How to install a Bluetooth kit - do things the easy way

There are two possibilities Bluetooth car kit can be installed, one of the most difficult path, the other is more easy (although very difficult, depending on the vehicle). The problem is, so Bluetooth kit with ISO connections as standard. ISO is an older industry standard that determines the positions of different lines (different functions), for example the front left and right, rear left and right, power, mute and power. If the vehicle is ISO, the kitis fairly easy to install.

The problem is that the ISO standard is quite old now. Vehicles using the most modern systems such as CAN-Bus and MOST fiber optic systems that do not use conventional cables. If this is the case, it is necessary to splice the cables (if possible) or use a mute cable, ISO2CAR, Drive & Mute or Audio2Car. All perform the same task, but each has a slightly different compatibility. For example Audio2Car particularly well with an increaseSystems.

Pioneer Wiring Harness

The only other difficult task when you install the Bluetooth kit is the microphone in place. These routes from the back of the Bluetooth device. Usually installed behind the stereo in the car. From here, its usually the best way the opposite direction of the driver. Remove the glove compartment, where it is always possible (different for each vehicle, but usually fairly painless if the screws are).

Remove the panel from the A-pillar of the vehicle, are usually non-ClipBut sometimes they are screwed, if so you should be able to get out of the clip plate airbags (show a clip of plastic where the airbag), a screw is usually found below this. You can also remove a few screws hidden before the band can be removed to be. A train on the wing mirror should allow you to install and route cables through the roof lining. (Do not pull too tight as you pull off perhaps the mirror, and can be a pain to reinstall) a metal layerHangers will be nice when you push through. From here on the A-pillar wire, avoid at all costs, and airbags did not tangle of wire around them. And away behind the glove compartment, the Bluetooth unit.

After this was done Thursday, control the power, ground (if necessary) and controls are active. The ignition is a must to check are the sets do not work with it. In fact, this is the most common cause of people think they have a defective unit. If your dishes do not have aPower (not all) is the best place is the fuse box or the cigarette lighter cable. A simple way to check is the ignition when the cables are connected. The unit should turn on.

Assuming that the kit is working properly again behind the stereo and the dashboard and panels, and the location of the microphone connected to your desired location close to the mirror (make sure not to be impeded). Pairing the phone with you to the manufacturer's instructions and you get a fully functionalBluetooth Car Kit (If you choose, you'll wonder how you ever lived with himself).

All in all, the task should not be longer than an hour of your time, if you have a vehicle particularly difficult as a BMW X5 (Due to the location of the device) or most Porsche (Because of the firewall) have.

Bluetooth car kits are known to improve the safety of drivers, if installed with the phone if you do not have in your vehicle. Do not use the phone number.